Hooking up a IF-2000 board to use with a LP-Pan

When you down load the instruction manual from RFSPACE it is all wrote for the FT 2000

Step one remove the top cover well after about 30 screws the manual is wrong. Itís the bottom cover.

Next they show you where to install the board also wrong the correct board below

Next remove jumper from pin ďHĒ thatís right but their picture wrong radio and the location is also wrong.

Correct location and board below



Next they show the external routing of the RF cable. The cable has a BNC connector cable is about three foot long


back.gif - (25K)